User Guide

254 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Action: For information on the specific error code, search the Error Codes online
documentation (http://www.novell.com/documentation/lg/nwec/docui/
index.htm). If the problem persists, contact a Novell support provider.
LOGOUT-X-180: You have only one network connection left. LOGOUT cannot detach
from it.
Source: LOGOUT.EXE
Explanation: This information message is notifying the workstation that the user tried to
break the last connection to the network.
LOGOUT-X-190: A default connection cannot be found.
Source: LOGOUT.EXE
Explanation: LOGOUT could not get the default connection identification number.
Action: Log out from a different drive. This changes the default connection to a
different server.
LOGOUT-X-200: You are not attached to any NetWare servers.
Source: LOGOUT.EXE
Explanation: This informational message indiates that the user tried to logout of the network
using the LOGOUT command. The workstation was not attached to any
NetWare servers; therefore, logout returned this message.
LOGOUT-X-210: No valid drives are available to assign default to.
Source: LOGOUT.EXE
Possible Cause: LOGOUT could not find a valid drive. When LOGOUT completely logs the
user out of all servers, it leaves the user attached to one of them, but it does
not leave the user logged in to it. LOGOUT tries to leave the user mapped to
a valid network, or to a local drive if a network is not found.
Action: Change to the local drive and try to log in again, or issue the MAP command
to see if any drives are available. If these attempts fail and the user cannot find
the LOGIN.EXE or MAP.EXE program, reboot the workstation and allow the
shell to connect it to a server that contains LOGIN.EXE or MAP.EXE.