User Guide

344 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWCONFIG-X-3: Fatal error: The installation cannot complete successfully. An
attempt to allocate memory failed. You must add (or reconfigure) memory and restart
the installation.
Source: NWCONFIG.NLM
Explanation: Memory is insufficient for NWCONFIG to run.
Action: Increase the memory available to the server. See Freeing Server Memory
Temporarily in the Server Operating System Administration Guide.
NWCONFIG-X-4: The disk partition table could not be read.
Source: NWCONFIG.NLM
Explanation: NWCONFIG was unable to read the disk partition information from the hard
disk.
Action: Make sure the disk is visible from DOS. If it is visible, try to read the partition
table with FDISK. If FDISK cannot see the disk, then the disk might be faulty.
If FDISK can see the disk but this error still appears, contact a Novell support
provider.
NWCONFIG-X-5: No information about device number could be obtained.
Source: NWCONFIG.NLM
Explanation: NWCONFIG was unable to read or write the disk partition table on device
number.
Action: See Disk Errors in the Server Operating System Administration Guide.
NWCONFIG-X-6: No disk partitions are defined on this drive.
Source: NWCONFIG.NLM
Explanation: This informational message indicates that the designated disk drive does not
contain a partition table. The server is probably using a new disk that has never
been formatted or partitioned before NWCONFIG will create a partition table.
NWCONFIG-X-7: An attempt to write out partition information failed. Error code: code.
Source: NWCONFIG.NLM
Explanation: While writing the partition information to the disk drive, the operating system
reported an error to NWCONFIG.
Action: See Disk Errors in the Server Operating System Administration Guide.