User Guide

NWCONFIG Messages 349
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWCONFIG-X-24: A volume was found with an invalid starting sector offset of
number. Check to be sure all disk drivers are configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid volume has been found. This volume has become corrupted.
Action: Delete the volume. If the data is required, restore it from backups. If the
problem persists, contact a Novell support provider.
NWCONFIG-X-25: A volume was found with an invalid segment length of number
starting at number on a drive of size number. Check to be sure all disk drivers are
configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid volume has been found. This volume has become corrupted.
Action: Delete the volume. If the data is required, restore it from backups. If the
problem persists, contact a Novell support provider.
NWCONFIG-X-26: A volume was found with an invalid FAT table 0, with a starting
block of number out of number total blocks. Check to be sure all disk drivers are
configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid volume has been found. This volume has become corrupted.
Action: Make sure disk drivers are configured correctly. Run VREPAIR. If these
efforts fail, delete the volume. If the data is required, restore it from backups.
NWCONFIG-X-27: A volume was found with an invalid FAT table 1 starting block of
number on a volume of number blocks. Check to be sure all disk drivers are
configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid Traditional volume has been found. This volume has become
corrupted.
Action: Make sure disk drivers are configured correctly. Run VREPAIR. If these
efforts fail, delete the volume. If the data is required, restore it from backups.