User Guide

350 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWCONFIG-X-28: A volume was found with an invalid directory table 0 starting block
of number on a volume of number blocks. Check to be sure all disk drivers are
configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid volume has been found. This volume has become corrupted.
Action: Make sure disk drivers are configured correctly. Run VREPAIR. If these
efforts fail, delete the volume. If the data is required, restore it from backups.
NWCONFIG-X-29: A volume was found with an invalid directory table 1 starting block
of number on a volume of number blocks. Check to be sure all disk drivers are
configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid volume has been found. This volume has become corrupted.
Action: Make sure disk drivers are configured correctly. Run VREPAIR. If these
efforts fail, delete the volume. If the data is required, restore it from backups.
NWCONFIG-X-30: A volume definition was found with a reserved area that is not filled
with zero data. Check to be sure all disk drivers are configured properly.
Source: NWCONFIG.NLM
Explanation: An invalid volume has been found. This volume has become corrupted.
Action: Make sure disk drivers are configured correctly. Run VREPAIR. If these
efforts fail, delete the volume. If the data is required, restore it from backups.
NWCONFIG-X-31: Due to a memory allocation problem, the volume definitions were
not updated on the disk.
Source: NWCONFIG.NLM
Explanation: There is insufficient memory to accomplish the desired update.
Action: Increase the memory available to the server. See Freeing Server Memory
Temporarily in the Server Operating System Administration Guide. Then try
the operation again.