User Guide

NWCONFIG Messages 355
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWCONFIG-X-51: An attempt to read a mirror file system directory entry failed.
Source: NWCONFIG.NLM
Explanation: An error occurred when the program attempted to read a volume.
Action: See Resolving Volume I/O Errors in the Traditional File Services
Administration Guide.
NWCONFIG-X-52: A file creation error occurred.
Source: NWCONFIG.NLM
Explanation: NWCONFIG could not write to a DOS or NetWare disk. If it is a diskette, it
might be bad, write protected, or not inserted correctly. If it is a hard disk, the
proper disk driver might not be loaded, the cabling might not be correct, or the
drive parameters might be set incorrectly.
Action: Make sure that there is a writable disk. Then check for the possible
explanations listed above. See Resolving Volume I/O Errors in the Traditional
File Services Administration Guide. If the problem persists, contact a Novell
support provider.
NWCONFIG-X-53: An invalid NetWare file path was found in a configuration file record
for the PRODUCTS.DAT file.
Source: NWCONFIG.NLM
Explanation: The SYS:SYSTEM\PRODUCTS.DAT file is corrupted.
Action: Run VREPAIR. If this does not work, delete the corrupted file and reinstall
PRODUCTS.DAT. If the problem persists, contact a Novell support provider.
NWCONFIG-X-54: An attempt to read a file failed.
Source: NWCONFIG.NLM
Explanation: NWCONFIG could not read from a DOS or NetWare disk. If it is a diskette,
it might be bad, might not be inserted correctly, or might not contain the
desired file. If it is a hard disk, the proper disk driver might not be loaded, the
cabling might not be correct, or the drive parameters might be set incorrectly.
Action: Make sure that there is a readable disk. Then check for the possible
explanations listed above. See Resolving Volume I/O Errors in the Traditional
File Services Administration Guide. If the problem persists, contact a Novell
support provider.