User Guide

398 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWCONFIG-X-298: Driver name on line number has no FRAME=<frame name>
parameter. All new Ethernet drivers that have no frame specified will now default to
Ethernet 802.2 frame type, whereas they previously used 802.3. Specify a frame
parameter for this driver.
Source: NWCONFIG.NLM
Action: If you want a frame type different from the default, you will need to specify it
later.
NWCONFIG-X-300: The network number you entered is the IPX internal network
number of this server; it cannot be used to bind to IPX. Enter a different (unique)
number.
Source: NWCONFIG.NLM
Explanation: The network address and the internal network number cannot be the same
number.
Action: If they are the same, change the internal network number of your server;
otherwise, enter the correct network address for this server.
NWCONFIG-X-301: No LAN drivers are loaded. LAN drivers must be loaded and
bound in order for NWCONFIG to communicate with other v4.x servers and install
Novell eDirectory as part of an existing eDirectory tree.
Source: NWCONFIG.NLM
Explanation: NWCONFIG could not communicate with any other servers because no LAN
drivers have been loaded.
Action: If you want NWCONFIG to see other servers on your network, load and bind
an appropriate LAN driver; then retry the operation.
NWCONFIG-X-302: No volumes were found.
Source: NWCONFIG.NLM
Explanation: There are no known volumes on this server.
Action: If you know that volumes exist on this server, make sure the correct disk driver
is loaded and all necessary disks are powered on and connected properly.