User Guide

NWCONFIG Messages 399
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWCONFIG-X-304: A physical device or partition in the set you selected is no longer
valid.
Source: NWCONFIG.NLM
Explanation: The device might have been powered off or in some other way made invisible
to NWCONFIG.
Action: Correct the problem and retry the operation.
NWCONFIG-X-305: Driver name was successfully loaded but not bound to any
protocol stacks. Press Enter to continue.
Source: NWCONFIG.NLM
Action: To bind the driver to a protocol stack, switch to the system console screen and
use the BIND command.
NWCONFIG-X-306: Driver name could not be loaded because command file name
could not be created. Load this driver manually from the system console.
Source: NWCONFIG.NLM
Explanation: Normally, the program automatically creates this file with the command
parameters in it, and command parameters are read from this file. However,
the LOAD command you entered was too long (over 200 characters), so you
will have to enter the command manually.
Action: Type LOAD driver_name parameters at the system console screen.
NWCONFIG-X-307: Driver name could not be loaded because command file name
could not be written. Load this driver manually from the system console.
Source: NWCONFIG.NLM
Explanation: Normally, the program automatically creates this file with the command
parameters in it, and command parameters are read from this file. However,
the LOAD command you entered was too long (over 200 characters), so you
will have to enter the command manually.
Action: Enter LOAD driver_name parameters at the system console screen.
NWCONFIG-X-308: No disk driver files (*.DSK, *.HAM, *.CDM) were found at this path.
Source: NWCONFIG.NLM
Explanation: The indicated files were not found at this location.