User Guide

NWTAPE Messages 455
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
NWTAPE Messages
The following includes messages from NWTAPE.CDM.
NWTAPE.CDM: WARNING! Driver has not been tested with device_name. The driver
has bound to the device to provide Generic support. Contact the device manufacturer
for a full-functioned driver.
Source: NWTAPE.CDM
Explanation: This driver has not been tested and certified by Novell.
Action: Contact the manufacturer to get a driver that fully supports the device and that
has been tested by Novell. However, if you want to use this driver, test it first
until you are satisfied that it supports the device adequately. Until then do not
use it to back up critical data.
NWTAPE.CDM: WARNING! Driver had an error with device name; therefore, driver did
not bind to device.
Source: NWTAPE.CDM
Explanation: There is a problem with some aspect of the hardware. The driver could not be
loaded.
Action: Check cables, termination, and the SCSI ID of the device. If these are not the
source of the problem, check the drive. It might need to be repaired or
replaced.
NWTAPE.CDM: WARNING! Device name is not SCSI-2 compliant. See if device is
jumper selectable to SCSI-2 mode.
Source: NWTAPE.CDM
Explanation: This is an older device that is not SCSI-2 compliant.