User Guide

528 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
SBCON-X-306: An error occurred while connecting to the TSA.
Source: SBCON.NLM
Possible Cause: The TSA is not loaded or there may be another problem with the TSA.
Possible Cause: Enhanced SBACKUP could not connect to the TSA.
Action: Load the TSA. If the TSA is loaded, unload and reload the TSA and SMDR.
Retry the operation.
SBCON-X-307: No Backup/Restore Target Services were found on this server.
Source: SBCON.NLM
Possible Cause: The workstation TSAs have not been registered to the TSAProxy.
Action: Make sure the workstation TSA is running.
Action: Set the preferred server through the TSA interface and submit the registration.
Action: Retry the operation. If the problem persists, contact your Novell support
provider.
SBCON-X-309: Could not connect to the Target Service
Source: SBCON.NLM
Possible Cause: Enhanced SBACKUP could not connect to the TSA.
Action: Verify that the correct user name and password were entered. Make sure to use
the fully distinguished name (FQN) for the user.
SBCON-X-311: Warning! You are not connected to any Target Service.
Source: SBCON.NLM
Possible Cause: You did not select a target service during job submission or the authentication
failed.
Action: Select a target service from the list, and provide the username and password
before submitting the job.
SBCON-X-317: QManager: Job name failed. Error number.
Source: SBCON.NLM
Possible Cause: The job failed to run.
Action: See the activity log, Sys:system\tsa\log\activity.log, for the cause of the
failure.