User Guide

SERVER Messages 545
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
SERVER-X-831: Process_name Process did not relinquish control frequently.
Module: name. Code offset in module: offset.
Source: SERVER.EXE
Explanation: Normally, NLM programs relinquish control of certain resources when a
higher priority request comes in or when a certain process is completed. This
message indicates that the NLM is not relinquishing control when it should,
preventing higher priority processes from executing.
Possible Cause: The NLM might be corrupted, or the server might have a prerelease version of
the NLM.
Action: Unload the NLM. Make sure the server has the most current version of the
NLM; then reload it from the original CD-ROM or diskettes. If the problem
persists, contact the vendor of the NLM.
SERVER-X-847: ERROR alias keyword too big.
Source: SERVER.EXE
Possible Cause: You created an alias keyword that was greater than 47 characters.
Action: Create an alias keyword of 47 characters or less.
SERVER-X-872: Insufficient memory to set up first load search path entry.
Source: SERVER.EXE
Explanation: When you executed SERVER.EXE, the server did not have enough memory
to create the initial search path to the DOS partition or to the Sys: volume on
the NetWare partition.
Possible Cause: The server is very low on memory.
Action: Add more memory.
SERVER-X-874: Insufficient memory to set up first load search path entry.
Source: SERVER.EXE
Action: See message “SERVER-X-872: Insufficient memory to set up first load search
path entry.” on page 545
SERVER-X-879: Invalid path specified.
Source: SERVER.EXE
Explanation: The specified path length value is less than two characters long.