User Guide

SERVER Messages 587
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
SERVER-X-5595: WARNING: number lost interrupt(s) detected on interrupt number.
Lost interrupt alerts occur when there are no interrupt request bits set in the
corresponding interrupt controller hardware when the processor acknowledges the
interrupt.
Source: SERVER.EXE
Possible Cause: A LAN card is probably failing.
Action: Note the interrupt number, then execute the CONFIG command at the server
console prompt to see a list of installed LAN cards and their interrupts. The
card using the specified interrupt is probably faulty. Replace the card.
SERVER-X-5596: WARNING: number spurious (unclaimed) interrupt(s) detected on
interrupt number. Spurious interrupt alerts occur when an interrupt is not claimed by
any of the registered handlers for that interrupt.
Source: SERVER.EXE
Possible Cause: A LAN card is probably failing.
Action: Note the interrupt number, then execute the CONFIG command at the server
console prompt to see a list of installed LAN cards and their interrupts. The
card using the specified interrupt is probably faulty. Replace the card.
SERVER-X-5653: ERROR occurred while modifying ALERT #number.
Source: SERVER.EXE
Explanation: You attempted to enable or disable the display of an alert, but an error
occurred. The alert code may not have been written correctly to allow the
enabling or disabling of the display.
Action: Contact the vendor of the module or code that displays the alert.
SERVER-X-5655: ALERT #number (name bit) was NOT enabled.
Source: SERVER.EXE
Explanation: You attempted to enable the display of an alert that cannot be displayed.
SERVER-X-5657: ALERT #number (name bit) was NOT disabled.
Source: SERVER.EXE
Explanation: You attempted to disable an alert that cannot be disabled.