User Guide

638 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Possible Cause: An internal problem occurred in the program.
Action: If the error persists, contact a Novell support provider.
17: The system could not create a new portal because the portal control block table
is full.
Source: utility name in message prefix
Possible Cause: Too many screens are active at one time. This is a program logic error.
Action: Contact a Novell support provider.
18: The system could not allocate additional memory.
Source: utility name in message prefix
Possible Cause: The workstation does not have sufficient memory to complete the attempted
operation.
Action: Increase the memory available to the workstation. See “Resolving
Workstation Memory Problems” on page 787.
19: The system cannot create a portal with a height of number and a width of number
because it is too large.
Source: utility name in message prefix
Action: Contact a Novell support provider.
20: The system could not seek a specific position in file name.
Source: utility name in message prefix
Possible Cause: The user does not have access rights to the file.
Action: Make sure the file is flagged properly.
Possible Cause: A file is corrupted.
Action: If the user has a corrupted file, replace it, if possible.
Possible Cause: A hardware failure occurred.
Action: Find out if other users and workstations are experiencing the same problem. If
so, contact a Novell support provider. If the problem persists and is isolated to
this workstation, check the hardware and cabling.