User Guide

640 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
24: The system could not push a list onto the stack because the list stack is already
full.
Source: utility name in message prefix
Possible Cause: To initialize a new list, the old list must be pushed onto the stack. The program
could not accommodate the request as described. Too many lists are active in
the program at one time. This is a program logic error.
Action: Contact a Novell support provider.
25: The system could not pop a list from the stack because the list stack is empty.
Source: utility name in message prefix
Possible Cause: The program attempted to retrieve a list when none was saved. This is a
program logic error.
Action: Contact a Novell support provider.
26: The system cannot display the utility header with the current date and time.
Source: utility name in message prefix
Possible Cause: The most likely cause of this error is a text string that is too long to display.
This could result from messages expanding due to translation.
Action: Contact a Novell support provider.
28: The system could not allocate number bytes of additional memory.
Source: utility name in message prefix
Possible Cause: The workstation does not have sufficient memory to complete the attempted
operation.
Action: Increase the memory available to the workstation. See “Resolving
Workstation Memory Problems” on page 787.
29: File name could not be opened.
Source: utility name in message prefix
Possible Cause: The user does not have access rights to the file.
Action: Make sure the file is flagged properly.
Possible Cause: A file is corrupted.
Action: If the user has a corrupted file, replace it, if possible.