User Guide

TIMESYNC Messages 689
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
TIMESYNC-X-92: Primary, reference and single servers should not follow a secondary
server. This server polled: server_name. The time exchange was ignored.
Source: TIMESYNC.NLM
Possible Cause: A Time Source List was configurated incorrectly. A Single Reference,
Primary, or Reference server was instructed to synchronize to a Secondary
server. This error only results from a custom configuration. It cannot occur
when SAP is used.
Action: Check the Time Source List in the TIMESYNC.CFG file for each Primary and
Reference server. The order of servers in the list determines the polling order.
Secondary servers should never be listed.
TIMESYNC-X-114: Synchronization Radius less than number will prevent
synchronization.
Source: TIMESYNC.NLM
Explanation: The Synchronization Radius parameter is set to a value lower than the current
correction floor setting for the TIMESYNC.NLM. The default
synchronization radius is 2000 milliseconds; the default correction floor
setting is 1 millisecond. (The correction floor parameter can be changed,
though normally it should not be.)
Action: Set the Synchronization Radius parameter to a value higher than the correction
floor setting. A value of 1000-2000 milliseconds (1-2 seconds) or higher is
usually adequate.
TIMESYNC-X-129: Synchronization Radius less than number will prevent
synchronization.
Source: TIMESYNC.NLM
Action: See message “TIMESYNC-X-114: Synchronization Radius less than number
will prevent synchronization.” on page 689.
TIMESYNC-X-133: Cannot allocate timer tag.
Source: TIMESYNC.NLM
Possible Cause: The server does not have enough memory available.
Action: Increase the memory available to the server. See Freeing Server Memory
Temporarily in the Server Operating System Administration Guide.