User Guide

758 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
003: Could not find TRXNET MLID to unload.
Source: TRXNET-DOS.LAN
Explanation: This is an informational message indicating that the TRXNET driver is not
loaded.
004: A TSR is loaded above the TRXNET MLID.
Source: TRXNET-DOS.LAN
Explanation: Another TSR (terminate-and-stay-resident) program was loaded after the
TRXNET driver.
Action: The drivers must be unloaded in reverse order, as follows:
C:\NWCLIENT\NETX /u <Enter>
C:\NWCLIENT\IPXODI /u <Enter>
C:\NWCLIENT\TRXNET /u <Enter>
Unload the TSRs; then try to unload the TRXNET driver. If you wish, you can
force the TRXNET driver to unload from the command line by using the /F
switch after the driver name, as follows:
C:\NWCLIENT\TRXNET /f <Enter>
Use caution when using the /F switch because it could cause the system to
hang.
005: TRXNET MLID could not be unloaded; the operation was aborted.
Source: TRXNET-DOS.LAN
Explanation: The TRXNET driver could not be shut down and unregistered. Consequently,
it cannot be unloaded.
Action: To unload the driver, reboot the system.
006: The adapter did not initialize. TRXNET did not load.
Source: TRXNET-DOS.LAN
Explanation: The TRXNET driver encountered an error while loading.
Action: Corrective action can vary. See the preceding driver-specific message on the
screen for specific information about the error that occurred.