User Guide

762 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
026: On a NetWare 3.11 server, you must load LSLENH.NLM before you load
MSM31X.NLM.
Source: NE1000-NW.LAN, NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
Possible Cause: The Link Support Layer (LSL) and Media Support Module (MSM) have been
loaded on a NetWare 3.11 server. An attempt was made to load
LSLENH.NLM. The computer cannot load LSLENH.NLM after the MSM
has been loaded. (LSLENH.NLM adds enhancement to the LSL.)
Action: Unload MSM31X.NLM; then load LSLENH.NLM. After the LSLENH.NLM
has been loaded, load MSM31X.NLM again.
050: The board cannot be found.
Source: NE2-NW.LAN, NE2000-NW.LAN, NE3200-NW.LAN
Possible Cause: The network board is not present in the computer, or the network board's
configuration cannot be obtained.
Action: Do one of the following:
 Make sure the network board is properly seated into the slot.
 Insert the network board into a slot, and run the Reference diskette to
install it.
Possible Cause: The network board settings are not the defaults, and they are not defined in the
AUTOEXEC.NCF file.
Action: If jumper settings are not the defaults, make sure they match the settings in the
AUTOEXEC.NCF file. If the computer is not using the AUTOEXEC.NCF
file, make sure the jumper settings are set to the defaults.
Possible Cause: Another network board is using the same hardware settings as this network
board.
Action: If other network boards are using the same hardware settings, change the
settings and try to reload the driver.
Possible Cause: The network board is faulty.
Action: Replace the bad network board.
050: [Microchannel] The board cannot be found.
Source: TRXNET-DOS.LAN
Explanation: If you are using a microchannel network board, the network board is not in the
machine, or the network board's configuration could not be obtained.