User Guide

770 System Messages
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
242: The Remove MAC Frame process shut down the adapter.
Source: CNTR2000.LAN
Explanation: The network board removed itself from the ring as requested by another
network board.
Action: Replace the network board with one that works.
A transmit timed out. The cable might be disconnected from the board.
Source: CNE2.LAN, CNE2000.LAN, CNE2_32..LAN
Explanation: The transmission process timed out. This could be due to one of two reasons:
the network cable is disconnected, or heavy traffic on the wire is delaying
packets from being sent.
Action: Check the cable to ensure the connection is good. If the cable connection is
good and the problem persists, network traffic might be heavy. Consider
redesigning the cabling to decrease LAN traffic.
An interrupt failed to occur during initialization.
Source: CNTR2000.LAN
Explanation: The network board never interrupted the host after it was reset.
Action: Replace the network board with one that works.
No interrupt was selected. The board must be reconfigured.
Source: CNE3200.LAN
Explanation: No interrupt was specified when the network board was installed.
Action: Run the EISA Configuration diskette that came with the computer, and select
an interrupt.
The board cannot be found.
Source: CNE2.LAN, CNE2000.LAN, CNE2_32..LAN, CNE3200.LAN
Explanation: The driver cannot find or recognize the adaptor board. Either the network
board is not present in the computer, or the network board's configuration
cannot be obtained.
Action: Make sure the network board is properly seated in the slot and properly
configured.