User Guide

Shared Messages for LAN Drivers 771
System Messages
103-000150-001
August 29, 2001
Novell Confidential
Manual 99a38 July 17, 2001
Also, refer to the manufacturer's instructions for configuring the network
board.
If the board still does not respond, replace it with one that works.
The board did not respond to the initialization command.
Source: CNEAMD.LAN, CNE2.LAN, CNE2000.LAN
Explanation: The LAN driver cannot get the network board to initialize. This could be due
to improper configuration or faulty hardware.
Action: Make sure the port and interrupt settings on the network board match the
settings in the configuration file.
Also, refer to the manufacturer's instructions for configuring the network
board.
If the board still does not respond, replace it with one that works.
The board has failed.
Source: CNE3200.LAN
Explanation: Firmware was downloaded to the network board, but the network board did
not accept commands. The board is not operating correctly, and it has failed.
Action: Check the network board and other hardware. If necessary, replace the
network board.
The board must be placed in a 16-bit slot.
Source: CNE2000.LAN
Explanation: The network board was placed in an 8-bit slot, but it was designed to operate
in a 16-bit slot.
Action: Move the network board to a 16-bit slot.
The board's DMA did not complete.
Source: CNE2.LAN, CNE2000.LAN
Explanation: The network board's remote Direct Memory Access (DMA) transaction did
not complete within the specified time. The driver will attempt to correct the
problem by resetting the network board and resending the packet.
Action: If the problem occurs often (more than once or twice a day), replace the
network board.