Operation Manual

novero Tour us

er guide

1.1

(

)

_ Every time the headset is turned on, it will automatically connect to the last

connected device. If you want to pair it with other devices, please turn off the

Bluetooth function of your last connected devices first and pair the headset

with the new device according to steps 1 to 6 mentioned above.

_ If the Bluetooth version of your mobile phone is V2.1 or above, there is no

need to enter the pairing password when the headset pairs with your mobile

phone.

5.3.3

5.3.35.3.3

5.3.3 Multi

MultiMulti

Multi-

-pairing

pairingpairing

pairing

The headset can be connected with two devices at most. One is a Bluetooth mobile

phone supporting HFP profile, the other one is a Bluetooth music device supporting

A2DP profile. If you want to use multi-pairing, please refer to the following steps:

1. Firstly, pair the headset with a music device.

2. Disconnect the music device, e.g. turn off the music device.

Pair and connect the headset with the Bluetooth enabled mobile phone (please refer

to chapter 0 “Pairing the headset with a Bluetooth enabled mobile phone”).

3. Turn on the music device again; it will automatically connect to the headset.

Note

NoteNote

Note _

_ After successful multi-pairing, the paired devices will remember each other.

Unless the pairing information is deleted because of new pairings, there is no

need to pair next time. If the pairing information is deleted, please make the

mobile phone and the headset to set up a hands free connection first and then

turn on the Bluetooth music device for multi-connection.

_ For mobile phones that support the HFP and A2DP, it may sets up the HFP

and A2DP connection with the headset simultaneously. At this time, the

Bluetooth music device will not connect to the headset.