Use and Care Manual

ManualsBrandsNovolink ManualsChristmas Decorations50 ft. 200 Light Mini Globe Cool White LED String Lights

Installation:

1. Before use and mounting, place the

light set on a clean, at surface and

check for any damage to the LED

lights, connections, interconnection

coupler, supply cord or adapter

plug.

2. Never use sharp or pointed objects

to install / mount a string light set

or chain.

3. Fixing with metal or braided wire,

or similar devices is not advisable.

Metal or braided wire can damage

the insulation layers of the light set.

4. Suitable installation devices include

cable conduits or soft cable ties.

When using cable ties, ensure they

are not excessively tightened to

the string to avoid damage to the

insulation layers of the light set.

5. The supply cord and rope body

must not be subject to push, pull or

torsion forces.

6. Ensure a correct and secure

connection between the supply

cord and the light chain coupler, as

well as for all interconnected light

chains. The end cap of the last

light set must always be in place

and tightened.

7. When connecting additional lights

to a set, make sure the Controller/

Transformer portion of the lights is

not plugged-in and powered.

8. Ensure that the light chain, supply

cord or interconnection couplers

are not located in or near running

water or drains (e.g. snow, streams,

rain gutters).

9. If the light set does not work, have

it checked by a certied technician.

Instructions for Use

Once the light set is properly mounted,

and attached to the power adapter,

plug the adapter into the appropriate

electrical outlet.

The lights should turn ON, and may

already be set to one of 8 settings,

including 6 ashing settings, one

steady setting, and one “All-in-One”

setting that cycles through all 6

ashing patterns.

Press the button on the control box to

select a dierent light mode. These

light modes include: “All-in-One”

Combination > Glimmer > Twinkle >

Sparkle > Flash > Starry > Pulse >

Steady > OFF.

LED String Lights

Thank you for purchasing our Novolink LED String Lights!

To insure proper installation and prior to use, please read these

instructions and all warnings thoroughly.

Need Add-on Extensions or

additional String Lights?

www.shopNovolink.com

Summary of content (2 pages)

PAGE 1
LED String Lights Thank you for purchasing our Novolink LED String Lights! To insure proper installation and prior to use, please read these instructions and all warnings thoroughly. Need Add-on Extensions or additional String Lights? www.shopNovolink.com Installation: 1. Before use and mounting, place the light set on a clean, flat surface and check for any damage to the LED lights, connections, interconnection coupler, supply cord or adapter plug. 2.
PAGE 2
Instructions for Use (Cont.) TIMER: The built-in timer can be activated by pressing the button on the controller for 3-5 seconds. It will keep the lights on for 6 hours after a light mode is selected. Afterwards, it will turn-OFF automatically. The light will turn-ON again after 18 hours unless the OFF mode is selected. Adding Extensions: Up to 2 extensions can be attached in a light string. Extensions for the string lights can be purchased at www.shopNovolink.com.