Datasheet

ManualsBrandsNovotechnik ManualsAngle & Rotary SensorsLinear Potentiometer Position Sensor 25mm 1kOhm

Special features

• long life up to 100 million

movements, depending on

application

• outstanding linearity -

up to ±0.075 %

• Repeatability to ±0.002 mm

• actuating shaft with double-

sided support

• special ball-coupling

eliminates sideways forces

• high operational speeds -

up to 10 m/s

• insensitive to shock and

vibration

• T-series with cable or TS-

series with connector versions

available

Position transducers

employing conductive plastic

tracks provide direct, accurate

measurement of travel in

display or control systems.

The push rod is supported on

both ends by metal glide

bearings, allowing high lateral

forces on the tip of the rod.

The elastomer-damped wiper

provides reliable contact when

experiencing shock or

vibration.

A ball coupling enables

backlash-free operation, even

with parallel or angular

misalignment. The coupling

may be fitted to either end of

the shaft

Position Transducer

potentiometric

up to 150 mm

Series T / TS

Page 1

Description

Housing aluminium, anodized

Mounting adjustable clamps

Actuating rod stainless steel AISI 303

Ball coupling hardened ball, external thread M5 x 0.5, with

spring pressure against hardened plate surface

Bearings both ends in glide bearings

Resistance element conductive-plastic

Wiper assembly precious metal multi-finger wiper, elastomer damped

Electrical connections

Series T

Series TS

3-wire, PVC-cable, 3 x 0.14 mm

, shielded, 2 m length

5-pin round connector IEC 130-9

Summary of content (4 pages)

PAGE 1
Position Transducer potentiometric up to 150 mm Series T / TS Position transducers employing conductive plastic tracks provide direct, accurate measurement of travel in display or control systems. The push rod is supported on both ends by metal glide bearings, allowing high lateral forces on the tip of the rod. The elastomer-damped wiper provides reliable contact when experiencing shock or vibration. A ball coupling enables backlash-free operation, even with parallel or angular misalignment.
PAGE 2
brown red orange Schematic Page 2 Schematic
PAGE 3
Type designations T-0025 TS-0025 T-0050 TS-0050 T-0075 TS-0075 T-0100 TS-0100 T-0150 TS-0150 with cable with plug Electrical Data Defined eletrical range 25 50 75 100 150 mm Electrical stroke 27 52 77 102 152 mm Nominal resistance 1 5 5 5 5 Resistance tolerance 20 kΩ ±% Independent linearity 0.2 Repeatability 0.002 0.15 0.1 0.075 0.
PAGE 4
Novotechnik U.S., Inc. 155 Northboro Road Southborough, MA 01772 Phone 508 485 2244 Fax 508 485 2430 info@novotechnik.com www.novotechnik.com © 02/2014 Subject to changes. Important All values specified in this data sheet for linearity, lifetime and temperatur e coefficient are only valid for a sensor used as a voltage divider with virtually no load applied to the wiper (ie < 1 μA). Included in delivery 2 mounting clamps Z-45 incl. 4 cylinder screws M4x10; 1 ball coupling.