Operating Instructions and Installation Instructions

Maintenance
Maintenance of the grease filter
The hood contains one metal filter which should
be cleaned twice a month.
Grease filter indication
After 20 cooking hours, the 4 LEDs will start to
blink during 5 minutes, this indicates that the
grease filter has to be cleaned. When replacing
the cleaned filter, you have to reset the hood by
pushing the – button during 5 seconds . If you
don’t reset, the LED lights will continu blinking.We
advise you to clean your filter twice a month for an
optimal operation.
Access to the filter
Open the rotating valve (A). Protect the hob. You
can take the grease filter (B) from the hood by
pulling the handle on the filter. The filter will come
down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Belangrijk! Indien de bovenvermelde instructies
niet worden uitgevoerd, ontstaat er door een
te sterke vervuiling, kans op brandgevaar en
rendementsverlies
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
The red LED will light up after 200 working hours
(time to regenerate the Monoblock recirculation
filter). The recirculation filter is to be found behind
the grease filter.
Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found
in its opening in the cooker hood. Remove it
from the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. The best solution for this
is to immediately regenerate the filter.
Reset the Monoblock recirculation filter
The cooker hood (motor) must be running!
Simultaneously press + and – for 5 sec. until the
red indicator lamp flashes 3 times for confirmation.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.
Deactivate the programming:
Attention! This is not recommended for a cooker
hood with recirculation.
Simultaneously press + and – for 5 sec. until the
third green LED flashes 3 times.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood. Use a soft, wet
cloth and a mild detergent to clean the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel. The
stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.
EN 16