Operating Instructions and Installation Instructions

Electrical connection
Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Replacing the lamps
Please allow the lights to cool down sufficiently
before touching them. Cover and protect delicate
surfaces underneath the hood when changing
lamps. The hood needs to be disconnected from
the current before proceeding.
1. Carefully slide down the spotlight holder and then
open the spotlight holder with a tilting movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be
replaced. Disconnect by means of releasing
the lock, by applying light pressure while at
the same time pulling away.
B. Next, remove the LED to be replaced by
making a gentle rotating movement to the
left.
3. Mounting the new LED:
A. Place the new LED light into the locking
ring.
B. Make a rotating movement to the right until
the LED light is locked.
C. Connect the power cable.
D. Put back the cover at its place.
EN 17