Operation Manual

NOXON iRadio Cube
ENGLISH 9
2.2 The power adapter socket ("POWER")
Plug the power adapter in here. Please use the supplied adapter.
While some universal power adapters feature the same plugs and
voltage, their amperage is not sufficient. Should you need a replace-
ment, please contact our service, see page 60.
2.3 WLAN antenna connector ("WLAN")
If you have access to a wireless LAN (WLAN), screw the antenna pro-
vided onto this connector.
If possible, ensure that the antenna is set to a vertical position to
ensure the best possible reception.
2.4 The network port ("LAN")
Use this port if you would like to integrate the NOXON into your net-
work via a wired connection. To distinguish it from the wireless or
WLAN connection, it is frequently referred to as a LAN or Ethernet
port. The port supports data rates of 10 and 100 Mbps. To connect
the NOXON to your router in this manner, use a standard network
cable (twisted pair with RJ45 plugs). To connect the NOXON "directly"
to your desktop PC or laptop, either use a network switch (also known
as a bridge) or a hub. To connect the NOXON without any intermedi-
ate devices, use a crossover cable instead of a standard network
cable.
Two LEDs near the port show the status of the link: they indicate a live connection to the network juncture
("node"); network traffic is signalled by a (green) LED.
2.5 FM antenna connector ("FM")
Still just white noise on the airwaves? For better reception, plug an
FM antenna (coaxial, 75 ohm) in here! The NOXON package includes
a handy dipole antenna, which fits this connector.