Operation Manual
4746
NOXON NOVA M
4. Getting Started
The items enclosed in the packaging box are as follows:
• NOXON NOVA M unit
• Power adaptor
• Audio cable with 3.5mm jack at both ends
• Telescope antenna for DAB+ and FM
• User manual (QSG)
Connect the power adaptor to the back of NOXON NOVA M and plug it into power socket.
Get the network environment ready
• For wireless WiFi
Make sure you have setup the wireless network and you have the WEP, WPA or WPA2
security password to activate the connection.
You may also use the WPS (WiFi Protected Setup) function for easy pairing between
the network device and NOXON NOVA. Check if the light indicators on the network
device are in appropriate status.
Switch it on from NOXON NOVA
At the rst time operation, system asks if you want to
start the Setup Wizard. Select YES to continue the
setup. Details of the Setup Wizard can be referred
to Section 5.2.1 below. After choosing NO, the next
screen asks if you would like to run the wizard next
time NOXON NOVA M is started.
NOXON will automatically connect to the network
that was set before when power on to Internet Radio
again. In case you desire to change the network,
enter System Setting to congure the corresponding
connection. Refer to Section 5.2.1 and 5.2.3.
Press STANDBY on the remote control to enter
standby mode. The time, date and any active
alarm times display on the screen.
Rotate the volume reel or press + / - on the remote control to adjust the volume or direct press
mute to mute the sound.