User guide

19
Press the +/- keys to select a channel. The current event
for this channel is shown below the channel # (e.g. ON,
OFF, dUR2, CYC4, SC03, NONE).
Press the OVERRIDE key to toggle the channel status
until the next event. Press the PROGRAM key then the
RUN key to cancel an override (this will not work for
timed external overrides). To exit the override mode
without making a change, press the PREVIOUS or
NEXT key to return to the override header, then press
the RUN key.
RUN
The RUN mode is the normal operating mode. In the
RUN mode the current time and day are shown. If today
is a holiday, the active holiday schedule is also shown.
Channel status is shown on the bottom line. The channel
number is shown if that channel is on. If the channel
number is flashing, that channel is currently overridden.
If it is flashing mostly on, the channel is overridden on.
If it is flashing mostly off, the channel is overridden off.
The input # is also shown along with the status of that
input. The following is a list of the possible input status
messages:
Message Input Config Status
NONE not config --
On\d On\d input closed
OFFd On\d input open, in delay
-N- On\d not active
OVd OVR overridden on w/
delay
?-V- OVR not active or
overridden on or off
without delay
ENb ENb input closed (enabled)
dISb ENb input open (disabled)
072F sensor, F sensor value