User guide

1
TORK MODEL
ELC78 EIGHT CHANNEL
ELC712 TWELVE CHANNEL
ENERGY AND LIGHTING CONTROL
READ INSTRUCTIONS CAREFULLY BEFORE
ATTEMPTING TO INSTALL TIME SWITCH. SEE
WARNING ON FRONT PANEL – Failure to comply with
instructions could result in personal injury and/or property
damage.
INSTALLATION:
UNIT IS TO BE INSTALLED BY A LICENSED ELECTRICIAN
1. To access mounting holes and terminal blocks, open
enclosure door (hinge on left) and internal circuit
board mounting plate (hinge on right.)
2. Mount the enclosure at eye level using screws
or other suitable fastening device. Bring supply
and load wires in through bottom or side knockouts.
USE TOP KNOCKOUTS FOR LOW VOLTAGE
WIRING ONLY.
3. Reinstall unit by reversing step #1 above and
connecting wires to units as per suggested
wiring diagrams at back of manual.
4. Remove battery insulator. Unit should be
programmed with AC power. Do not program under
super cap back up power.
CAPABILITIES
- 7 day scheduling
- 128 set points
- Astronomic programming
- 4 Signal (duration) programs
- 4 Duty Cycle programs
- 26 Holidays
- 10 Block holidays
- 8 Inputs for switches or photo sensor