User guide

4
3.0) ASTR – Set sunrise, sunset times and latitude
4.0) EVNT – Set ON time at 4:00pm and OFF time
(example: 11:30pm)
5.0) INPT - Skip
6.0) EVNT SENS - Skip
7.0) HOL - Set holidays as required or skip
8.0) RUN – Update schedule for operation
E: Photo ON and OFF
1.0) TIME – Set time, date, daylight savings time dates
2.0) CONF – Skip
3.0) ASTR – Skip
4.0) EVNT – Skip
5.0) INPT - Configure input wired with photo sensor
6.0) EVNT SENS – Set sensor event for 12:00am ON
7.0) HOL - Set holidays as required or skip
8.0) RUN – Update schedule for operation
F: Photo ON and Time OFF
1.0) TIME – Set time, date, daylight savings time dates
2.0) CONF – Skip
3.0) ASTR – Skip
4.0) EVNT – Set OFF time (example: 11:30pm)
5.0) INPT - Configure input wired with photo sensor
6.0) EVNT SENS – Set sensor event for 9:00am ON
7.0) HOL - Set holidays as required or skip
8.0) RUN – Update schedule for operation
0.0 INITIAL POWER-UP OR RESET
The control will display MEM CLR (memory clear).
This is only accessible once. It indicates that the
memory has been cleared.
Use the NEXT key to begin set-up.
0.1 CONTACT OPERATION
Toggle between MAINTAIN (maintained) or
MOMENTARY operation using the +/- key.