User's Manual

MiCard Installation Guide_english_V2.doc
© NT-ware 5
Important Note:
Changes and/or modifications of the MiCard not approved by NT-ware
Systemprogrammierung GmbH will void the user’s authority to operate the
MiCard!
FCC Compliance Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more
of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Requirements
Rating: 5 V
USB 1.1 Full Speed
Ambient temperature 0 … +50 °C
Canon iR:
- has to be MEAP enabled
- USB Application Interface board of the respective iR
- uniFLOW Login Manager/Secure Public Printing Applet v2.1.0
uniFLOW OM:
- uniFLOW OM/RPS v3.1 required /
uniFLOW OM / RPS v3.1.1. recommended