User's Manual
Table Of Contents
- 1 Introduction
- 2 Available Models
- 3 Scope of Supply
- 4 Technical Specifications
- 5 FCC and IC Compliance Notes
- 6 Ports
- 7 Supported Card Standards
- 8 LED / Beep Status
- 9 Mounting Options
- 10 Copy Control Cables
- 11 Installation
- 12 Configuration
- 13 Job Release via uniFLOW Release Station
- 14 Index
uniFLOW Release Station
3
4 Technical Specifications
Power Supply:
The power supply must be a limited power source (LPS), which delivers a
voltage of 12 V DC and a min. current of 1.0 A. A polarized plug 2.1/5.5
mm is to be used, with positive wire to the inner jack.
Rated Voltage:
12 V LPS
Ethernet:
2x RJ-45 Ethernet connection with a built in 10/100 MBit switch.
USB:
USB Type A connection with USB 2.0 (Hi-Speed) to connect a USB
identification device.
D-SUB-15:
Digital I/O Connector to lock / unlock the machine for copy accounting.
D-SUB-15HD:
Digital I/O Connector to lock / unlock the machine for copy accounting.
Ambient
temperature:
0 … +35 °C (32 … +95 °F)
Safety restrictions:
Use only in closed rooms.
uniFLOW:
uniFLOW and/or RPS V5.3 or higher
Status LEDs:
The uniFLOW Release Station is equipped with different LEDs depending
on the built in card reader. See chapter LED/Beep Status (see "LED / Beep
Status" on page 9) for more info.
Changes and/or modifications of the uniFLOW Release Station not approved by
NT-ware Systemprogrammierung GmbH will invalidate the user’s authority to operate
the uniFLOW Release Station.
FCC IC