User's Manual
Table Of Contents
- 1 Introduction
- 2 Available Models
- 3 Scope of Supply
- 4 Technical Specifications
- 5 FCC and IC Compliance Notes
- 6 Ports
- 7 Supported Card Standards
- 8 LED / Beep Status
- 9 Mounting Options
- 10 Copy Control Cables
- 11 Installation
- 12 Configuration
- 13 Job Release via uniFLOW Release Station
- 14 Index
uniFLOW Release Station
6
6 Ports
1. Network port 1:
To connect the uniFLOW Release Station to the printer or to the network.
2. Network port 2:
To connect the uniFLOW Release Station to the printer or to the network.
3. USB port:
Used to connect an additional MiCard USB card reader to the uniFLOW Release
Station.
4. Copy Control port 1:
To connect a copy control cable.
5. Copy Control port 2:
To connect a copy control cable.
6. RJ45 port:
Only for internal use.
7. Power input jack:
To connect the external power supply.