User's Manual
Table Of Contents
- 1 Introduction
- 2 Available Models
- 3 Scope of Supply
- 4 Technical Specifications
- 5 FCC and IC Compliance Notes
- 6 Ports
- 7 Supported Card Standards
- 8 LED / Beep Status
- 9 Mounting Options
- 10 Copy Control Cables
- 11 Installation
- 12 Configuration
- 13 Job Release via uniFLOW Release Station
- 14 Index
uniFLOW Release Station
18
12.2.2 Card Reader
If you own a uniFLOW Release Station PLUS, you can upload a MiCard PLUS
configuration file here in order to configure the build-in MiCard PLUS card reader with
specific settings. The configuration file can be created using the MiCard PLUS
configuration utility (pcProxConfig.exe):
1. Download the newest version of the MiCard PLUS configuration utility.
To download the file, please refer to MANUAL - uniFLOW Release
Station - Installation and Configuration (MOMKB-770) in the
NT-ware Knowledgebase.
Please note that registration is required in order to access the
NT-ware Knowledgebase.
2. Install and run pcProxConfig.exe.
3. Select File > Save USB device hex raw data to (SDK) file ...
The option Save USB device hex raw data to (SDK) file ... is only
available in the new versions of the pcProxConfig.exe.
4. Save the configuration text file.
5. On the uniFLOW Release Station Card Reader site, browse for the configuration
text file and click Upload & Configure.
For more information, please refer to chapter MiCard Configuration in the uniFLOW
User Manual.
Upload & Configure:
Uploads the configuration file to the uniFLOW Release Station and applies the
settings.