Owner manual

ManualsBrandsNTi Audio ManualsAudio accessoriesFLEXUS FX100

AUDIO TEST & MEASUREMENT SOLUTIONS

www.nti-audio.com Apr 11, Page 1 / 4

FLEXUS FX100

AUDIO ANALYZER

PACKAGE LIST

FLEXUS FX100 Audio Analyzer•

Mains cable•

USB cable•

FLEXUS CD (PC software and product information)•

Calibration certiﬁcate•

This quick guide•

OPERATING CONDITIONS &

SAFETY ADVICE

Required mains power: 90 - 264 VAC / 47 - 63Hz.•

Maximum voltage at analog inputs: 200Vp.•

Do not apply AC voltages to analog outputs.•

Environmental conditions•

Operating: 5°C to 45°C / 90% RH non-condensing.•

Storage: -20°C to 80°C / 90% RH non-condensing.•

You may stack up to four FLEXUS units.•

Keep front panel ventilation inlet holes open.•

For detailed speciﬁcations see www.nti-audio.com/ﬂexus•

MAINTENANCE

There are no serviceable parts inside.•

Clean surface with a dry cleaning cloth. You may use a mild cleaning •

agent if required.

QUICK GUIDE

Summary of content (4 pages)

PAGE 1
AU D I O T E S T & M E A S U R E M E N T S O L U T I O N S F L E X U S F X 1 00 AU D I O A N A LY Z E R QUICK GUIDE package List • • • • • • FLEXUS FX100 Audio Analyzer Mains cable USB cable FLEXUS CD (PC software and product information) Calibration certificate This quick guide OPERATing Conditions & Safety advice • • • • Required mains power: 90 - 264 VAC / 47 - 63Hz. Maximum voltage at analog inputs: 200Vp. Do not apply AC voltages to analog outputs.
PAGE 2
introduction Make yourself familiar with the connections, controls and elements of your FLEXUS audio analyzer. Pass/Fail Indications Display Push & Turn Operating Wheel Headphone Jack FLEXUS FX100 AUDIO ANALYZER On/Off Switch USB - Type A ON / OFF Ventilation Air Inlets Grab Handle Balanced In Unbalanced In Digital IO Port UNBAL CH2 FX-GEN UNBAL USB LAN Power: 90 – 264 VAC 47 – 63 Hz USB - Type A USB - Type B Ethernet Fuse: FX100 -1.6A FX200 -3.15A CH2 FX-ANA FX-CTRL Spare Slots www.
PAGE 3
start of operation 1. Unpack items. 2. Install software. • Insert FLEXUS CD into the CD drive of your PC. • Open CD drive folder and double-click on setup.exe. • Follow installation instructions. 3. Connect FLEXUS to mains power. 4. Connect FLEXUS and PC with USB cable, using the USB-B connector. 5. Launch FX-Control. 6. FX-Control will start with a default measurement project 7. For further information on how to operate FX-Control, please use the online help via the “F1” key. how to ...
PAGE 4
Set the FLEXUS date and time • Select the FLEXUS menu SYSTEM → =TIME • Set the correct date and time. Configure the headphone output Content Source Volume Content: • MONITOR (the unfiltered analyzer input signal). • PURESOUND (the bandlimited PureSound analysis input filter). Source: • The analyzer channel number routed to the headphone output.