Instruction Manual

44
6 Regulatory compliance information
6.1 USA – Federal Communications Commision (FCC)
FCC ID: 2AVEZHV0002
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
The changes or modifications not expressly approved by NTN Corporation could void the user's authority
to operate the equipment.
6.2 Canada – Innovation, Science and Economic Development Canada (ISED)
IC: 25934-HV0002
Model: DAT-HV0002
CAN ICES-003(A)/NMB-003(A)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
1.This device may not cause interference.
2.This device must accept any interference, including interference that may cause undesired operation
of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1.L’appareil ne doit pas produire de brouillage
2.L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
6.3 Caution for exposure to Radio Frequency (RF) radiation
This device must be installed to provide a separation distance of at least 20 cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter.
Cet appareil doit être installé de manière à fournir une distance de séparation d'au moins 20 cm de toutes
les personnes et ne doit pas être colocalisé ou fonctionner avec une autre antenne ou un autre émetteur.