Safety Information

Page 33 of 60 Report No. WUX202107133461UL
UL 62368-1
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC62368_1C
Largest capacitance and smallest resistance for
ICX tested by itself for 10000 cycles test
.................
:

G.16.3
Capacitor discharge test
.............................................
:
N/A
H
CRITERIA FOR TELEPHONE RINGING SIGNALS
N/A
H.1
General
N/A
H.2
Method A
N/A
H.3
Method B
N/A
H.3.1
Ringing signal
N/A
H.3.1.1
Frequency (Hz)
...........................................................
:

H.3.1.2
Voltage (V) ...................................................................:

H.3.1.3
Cadence; time (s) and voltage (V) ........................... :

H.3.1.4
Single fault current (mA):............................................:

H.3.2
Tripping device and monitoring voltage
N/A
H.3.2.1
Conditions for use of a tripping device or a
monitoring voltage
N/A
H.3.2.2
Tripping device
N/A
H.3.2.3
Monitoring voltage (V)
.................................................
:
N/A
J
INSULATED WINDING WIRES FOR USE WITHOUT INTERLEAVED
INSULATION
N/A
J.1
General
N/A
Winding wire insulation............................................... :

Solid round winding wire, diameter (mm)
................
:
N/A
Solid square and rectangular (flatwise bending)
winding wire, cross-sectional area (mm
2
)................ :
N/A
J.2/J.3
Tests and Manufacturing
(See separate test report)

K
SAFETY INTERLOCKS
N/A
K.1
General requirements
N/A
Instructional safeguard
...............................................
:
N/A
K.2
Components of safety interlock safeguard mechanism
N/A
K.3
Inadvertent change of operating mode
N/A
K.4
Interlock safeguard override
N/A
K.5
Fail-safe
N/A
K.5.1
Under single fault condition
N/A
K.6
Mechanically operated safety interlocks
N/A
K.6.1
Endurance requirement
N/A
K.6.2
Test method and compliance
.....................................
:
N/A