Instructions / Assembly

ManualsBrandsNu-Flame ManualsHeating, Ventilation, and Air Conditioning8 ft. Gardenfall Bio-Ethanol Fire-Fountain - Stainless Steel and Clear Glass

1. Remove the Gardenfall panel from its shipping carton.

2. Lean the glass panel upright against a wall until you reach step 6.

3 Move all the packing material from the base including: the light kit, bag of river rocks

and pump/filter/valve assembly.

4 Take the valve assembly and attach it to the threaded opening on the pump by

screwing it in (figure A). Also attach the sponge filter to the threaded opening on the

side of the pump (figure B).

5. Place the assembled pump/filter/valve assembly into the reservoir with the valve next

to the side that has the hole cut out for the cord (figure C). Remove cord strain relief

(figure D). Pull the cord through the hole, leaving approximately 12 inches of the cord

in the base (See figure E). Apply strain relief to cord (figure F).

6. Take Gardenfall panel from step 2, and with 2 people, slide the panel into the center of

the base as shown in figure G. (Note: place cardboard over base to protect it from

scratching, do not rest the Gardenfall panel directly on the base as this may scratch the

base). It is important to place the panel in the reservoir to the side with the plumbing

coming out of the bottom.

Note: The side that has the peel-off sticker labeled "front" is the side that the

water flows down and should be facing front.

figure G

figure F

figure E

figure D

figure C

figure B

figure A

72"- 90” GARDENFALL Waterfall

72"- 90” GARDENFALL Assembly

Instructions for use

Light/Bracket with transformer (1) Pump/Filter/Valve Assembly(1)

Metal Trays for Rocks (2) Bag of River Rocks (1)

Cord Strain Relief (1) Cable Clips (5)

PARTS List

Inspect for shipping damage- any damage from shipping should immediately

be reported to the delivery agent. Do not attempt to operate if unit is damaged.

72"

90”

BLUWORLD

of water

blu

Summary of content (8 pages)

PAGE 1
blu 72"- 90” GARDENFALL Waterfall BLUWORLD of water I n s t ru c tio n s fo r u se 72 " or 90 ” Inspect for shipping damage- any damage from shipping should immediately be reported to the delivery agent. Do not attempt to operate if unit is damaged. PARTS List Light/Bracket with transformer (1) Pump/Filter/Valve Assembly(1) Metal Trays for Rocks (2) Bag of River Rocks (1) Cord Strain Relief (1) Cable Clips (5) 72"- 90” GARDENFALL Assembly 1. Remove the Gardenfall panel from its shipping carton.
PAGE 2
figure I figure H figure K figure L figure N figure J figure M .7 Once the panel is placed in the base, turn the thumb screws (as shown in figure H) to secure the panel in the base. .8 Line up the pump/filter/valve assembly to the hose coming out of the panel, as shown. Simply hand screw the two connections together. See figures I and J. NOTE: Assembly must lay flat on base floor to avoid hot burner. Position filer and valve to the back of the base.
PAGE 3
Maintenance of the PUMP Open the pre-chamber B, turning counter-clockwise local water, you may need to add the recommended (loosen the safety screw prior to this operation). Slip the chemicals and change the water more frequently to rotor D off the pump body E, taking care not to damage avoid excess build up. If these conditions are present it the the ceramic shaft L and the supporting rubber pads is recommended to use distilled water to operate your M and N.
PAGE 4
CARE AND MAINTENANCE IN ORDER TO CLEAN THE GLASS SIMPLY REMOVE THE HEADER AND UNSCREW THE STAINLESS STEAL DISTRIBUTION PANEL. SLIDE THE GLASS PANEL UPWARDS TO REMOVE IT FROM THE BASE. FILL THE BASIN WITH WATER AND PLUG INTO A STANDARD ELECTRICAL OUTLET. DO NOT ATTEMPT TO MOVE THE DISPLAY ONCE IT IS FILLED WITH WATER. EMPTY THE BASIN BEFORE REMOVING FROM THE WALL. MAINTAIN THE WATER LEVEL BY FILLING TO BELOW THE TOP EDGE OF THE BASIN ABOUT ONCE A WEEK.
PAGE 5
BURNER MANUAL Read and understand the entire Burner Manual prior to use. Please store these safety warnings in a safe place for future reference. NOTICE: BUYER ASSUMES ALL RESPONSIBILITY FOR SAFETY AND USE THAT IS NOT IN ACCORDANCE WITH INSTRUCTIONS AND WARNINGS. We all understand fire is dangerous but for many years it has been safely used and enjoyed when properly handled.
PAGE 6
First-Time Use Instructions Your fire fountain is for decorative purposes only and not suitable for continuous operation. Do not use the Fire to heat or boil water or as a cooking appliance. Do not put wood, charcoal, paper or other combustible objects into the Fire. 1. PLACEMENT OF FIRE FOUNTAIN: This FIRE FOUNTAIN will use oxygen from the air inside the room where it is operated. The rooms should be well ventilated with enough oxygen and fresh air being supplied (i.e.
PAGE 7
Relighting & Refilling WARNING: DO NOT ATTEMPT TO ADD FUEL TO BURNER OR BURNER CUP IF FLAME IS PRESENT OR BURNER/CUP IS HOT, THIS MAY CAUSE A FLASH FIRE AND SEVERE BURNS. FLAME MAY BE NEARLY INVISIBLE: APPROACH FIRE WITH CAUTION. Always follow shut-off procedure before refueling 1. SHUT BURNER OFF WITH DAMPENER/SLIDER PROVIDED OR ALLOW FUEL TO BURN OUT COMPLETELY. ALLOW 30 MINUTES FOR UNIT TO COOL BEFORE REFUELING. WAIT FOR THE WINDSCREEN AND BURNER/CUP TO COOL TO ROOM TEMPERATURE.
PAGE 8
Attention: New Warranty in effect as of April 1, 2012 Bluworld’s® Warranty has changed as of April 1, 2012 and supersedes all previous warranties for product purchased after April 1, 2012. If there is printed material within this shipment it is considered void and the Warranty as stated below is policy. Bluworld® product is warranted against defects that render it unfit for its reasonably intended use.