Owners manual

635 W. Michigan Street Orlando, FL 32805 · PH 407-426-7674 · Fax [phone]
http://shop.bluworldusa.com · www.nu-flame.com
SETUP INSTRUCTIONS FOR CANNELLO
Read and Understand the entire Nu-Flame Manual prior to use.
Make certain to inspect the package thoroughly. Carefully remove and unwrap your Nu-Flame
fireplace.
Your fireplace will have the following components:
1. Black Fireplace
2. Stainless Steel Burner
3. Safety Mounting Bracket (3 pieces)
4. Glass Wind Screen
5. Stainless Steel Glass Holder Stand-off Tubes with Thumb Screws (4 each)
6. Hardware Bag
7. Dampener tool
You may wish to purchase a funnel for pouring fuel into the burner
Take the thumbscrew off one end of each
standoff. From the front of the backer thread
the screw of each standoff into each 4 corner
holes. From the back thread each thumbscrew
onto each standoff and tighten.
Lay the fireplace on its back, remove the thumb
screws from the stand-off tubes and place the
wind screen glass over the tubes so the holes
align. Replace the thumb screws and tighten.
Place the burner into the burner base, the
opening of the burner will face away from the
wall. Make certain the burner is well seated and
sitting level.