User Guide

2 SafeCom Go Canon
D60707-18 27
2.8.10 Restore factory default
1. Open the Configuration web page (2.7.3).
2. Click Restore.
2.8.11 Determine the version
The version of the SafeCom Go Canon software can be determined from the
Information web page.
1. Open the Information web page (2.7.2).
The version can also be seen in the Device properties dialog in SafeCom
Administrator.
2.8.12 Select SafeCom Go login as login service
1. Open a web browser and enter the IP address of the MFP in the address
field followed by :8000/sms. Example:
http://172.16.6.55:8000/sms
Use of JavaScript (Active Scripting) must be enabled in the browser.
2. Enter Password. The default SMS password is: MeapSmsLogin.
3. Click Log In.
4. In the browser click on the System Management tab.
5. Click on the Enhanced Sys. App tab.
6. In the Login Service section select SafeCom Go Login.
7. On the control panel press and hold the power button to restart the MFP.
2.8.13 Update the version
If you are updating from a previous version to S88 010.010*03 you need to
uninstall the previous SafeCom Go Canon version first. This is because the
product now has a new ID.
1. Uninstall SafeCom Go Canon (2.9)
2. Install the new SafeCom Go Canon (2.4).
2.8.14 HP Access Control USB proximity card reader (HP M24)
To use the HP Access Control USB proximity card reader (also known as HP M24)
you need to use SafeCom G4 and you MUST have an ID Device license associated
with the device. In SafeCom Administrator open the Device properties dialog,
go to the License tab and ensure that ID device is checked.
The HP M24 reader can support two different technologies. The HP M24 reader
must be programmed prior to connection to the Canon device. Below is a list of
the HEX codes and what card type they correspond to.