User's Manual

NUCTECH COMPANY LIMITED
15
(1) Open the sliding cover to wake up the entire system, or touch the screen lightly to wake up the
system.
(2) Enter any previously added non-temporary fingerprint, and then enter another non-temporary
fingerprint when you hear "Enter Fingerprint" after beeping
(3) When the LED indicator light turns green or you hear "Ding Dong", press down the handle to
open the door.
6.3. [Fingerprint + password] mode
In this mode, you can unlock the door with any non-temporary fingerprint + administration password.
The specific steps are as follows:
(1) Open the sliding cover to wake up the entire system, or touch the screen lightly to wake up the
system.
(2) First of all, enter any previously added non-temporary fingerprint, and then enter the
administration password when you hear "Enter Fingerprint” after beeping; or enter the administration
password at first, and then enter any previously added non-temporary fingerprint after pressing [#].
(3) When the LED indicator light turns green or you hear "Ding Dong", press down the handle to
open the door.
6.4. Mechanical key
If you forget the password, or the fingerprint is unrecognizable, the batteries run out or the system is
unable to work normally, the mechanical key can be used to unlock the door. Insert the designated
mechanical key into the keyhole at the bottom of the front surface plate and rotate it by 90°, and then
press down the handle to open the door (if the latch bolt and the deadbolt cannot be opened by the
mechanical key, the key must not be rotated forcefully so as to avoid being damaged). Meanwhile, it
will give a sound-light alarm for one minute. The alarm can be canceled through entering the Admin
fingerprint or user fingerprint.
6.5. Card
This function is optional. If you forget the password or the fingerprint is unrecognizable, wake up the
system and swipe the previously added card on the touch screen to unlock the door.
6.6. Locking door
The door can be locked outdoors only by lifting the external handle.
The door can be locked indoors only by lifting the internal handle.
Rotate the back locking thumb turn for indoor back locking. At this moment, the door can be opened
only by entering the Administrator fingerprint or password.
1
．
If the fingerprint is entered wrongly for 5 consecutive times, the system will enter the standby
state, and then it is necessary to wake up the system again before operation.
2． If the password is entered wrongly for 5 consecutive times, the system will be self-locked for 1
minute and give an alarm, and the LED indicator light will turn red and flash at the same time.
3． In the normal use, the system will give a low-voltage alarm when it is awakened each time after
the batteries are lower than 5V, the LED indicator light will turn red and flash, and there will be a
voice indicating “Low Power. Please Replace the Batteries”.
4． This smart lock supports the front virtual-digit and back virtual-digit passwords. As long as the
unlocking password entered contains a complete and effective password combination, the door can
be opened, but the total digital number of the password entered shall not be more than 20.
5
．
Operation results can be determined by observing the LED indicator light in the mute mode:
blue represents the normal state, red represents the operation fails, and green represents the
operation is successful. In the voice mode, besides judging the operation results by the LED
indicator light, the results can be judged through the voice indications: “Ding Dong” means the
operation is successful, and “Beeping” sound means the operation fails.
Notes