User Manual

Federal Communication Commission Interference

Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to two different Part 15 rules sections of the FCC. These

limits are designed to provide reasonable protection against harmful interference in

a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

. Reorient or relocate the receiving antenna.

. Increase the separation between the equipment and receiver.

. Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

. Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, any changes or modifications not

expressly approved by the party responsible for compliance could void the user's

authority to operate this equipment. (Example - use only shielded interface cables

when connecting to computer or peripheral devices).

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with a

minimum distance of 0.5 centimeters (.20 of an Inch) between the radiator and your

body.

This transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

The antennas used for this transmitter must be installed to provide a separation

distance of at least 0.5 centimeters (.20 of an Inch) from all persons and must not be

co-located or operating in conjunction with any other antenna or transmitter.

This device complies with two different Part 15 rules sections of the FCC. Operation is

subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must accept

any interference received, including interference that may cause undesired

operation.