HDP 1 ____________________________________________________________________________________________________ __ 382 South Abbott Avenue, Milpitas, CA 95035, USA • PHONE: +1-408-890-6840 • FAX: +1-408-262-6877 nuforce.com • EMAIL: salesteam@nuforce.
FCC Notice “Declaration of Conformity Information” This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy. If not installed and operated in accordance with the instructions, it may interfere with radio communications.
WARNING: Never attempt to disassemble, repair or make any modification to your device. Disassembly, modification or any attempt at repair could cause bodily injury or property damage, as well as damage to the device itself. WARNING: Your device is not a toy. Never allow children to play with your device. Misuse, rough or improper handling of your device by children could result in serious bodily injury for any of the enumerated safety warnings in this manual.
NuForce Icon HDP The Nuforce Icon HDP incorporates a full-speed USB DAC and full-function S/PDIF D/A converter, plus a headphone-amplifier circuit and preamp output. Supporting digital USB, S/PDIF in coaxial and 3.5mm optical (3.5mm) modes, along with an analog line input, the HDP's flexibility has been designed to accommodate all manner of audio devices.
Checklist The following are included with the Icon HDP: Vertical stand AC adapter AC power cord USB cable Optional Accessories: Linear power supply High performance USB cable Operating Instructions: The front panel label shows U (USB), D (digital) and A (analog) for the input selector knob. When in the D position, if an optical plug is inserted into the 3.5mm, the coaxial gets cut-off. If the 3.5mm analog is inserted in the A position, the RCA gets cut off. The 3.
DAC and Headphone Amp User Guide Introduction CD-ripping software is capable of reproducing “bit perfect” digital music data (16 bit/44.1kHz) from audio CD files stored on the computer’s hard drive. In addition to CD-quality music, some online sites are now offering 24 bit/96kHz music files. Thanks to larger and increasingly economical hard-disk capacity, consumers can store the highest quality music files on their computers. However, extracting good sound from the computer poses problems.
Windows PC Driver Optimization ASIO4ALL is a hardware-independent, low-latency ASIO driver for WDM audio devices that employs WDM Kernel-Streaming and other sophisticated methods. What You Should NOT Do Do not tamper with or replace your existing sound-card drivers. Do not install any kernel-mode components that might affect your system’s stability. Do not “over-clock” or operate your audio hardware in ways that have the potential to do harm. This will void your warranty.
design can mitigate. In the case of IE headphones, noise can be minimized or all but eliminated by reducing the amplifier’s gain. But to do that, the advantage the amp offers to OE headphone users would be sacrificed. Performance benefits for one type of product diminishes those of the other. As always, effective engineering requires compromise..In this regard, the NuForce Icon Series of products offer good, real-world solutions. Noise will be low in some cases, and in others, quite imperceptible.
TERMS AND CONDITIONS OF SALE Section 0.Warranty coverage. Refer to “Nuforce Limited Warranty” section. Scope. These terms and conditions of sale (these “Terms”) apply to all sales of products (the “Products”) by Nuforce Inc. (“NuForce”), a California corporation, to buyer of the Products ("Buyer").
INDEMNIFY, DEFEND AND HOLD HARMLESS NUFORCE FROM AND AGAINST ANY AND ALL LIABILITIES, DAMAGES, COSTS AND EXPENSES RELATED TO ANY WARRANTIES WITH RESPECT TO THE PRODUCTS OTHER THAN THOSE SET FORTH IN SECTION 0 OR ANY USE OF THE PRODUCTS OR RESALE OF THE PRODUCTS. Liability.
product at no charge, using new or refurbished replacement parts, (2) exchange the product with a product that is new or which has been manufactured from new or serviceable used parts and is at least functionally equivalent to the original product, or (3) refund the purchase price of the product. A replacement product/part assumes the remaining warranty of the original product or ninety (90) days from the date of replacement or repair, whichever provides longer coverage for you.