User Guide

nVent.com | 13
SECTION 2: SETUP/PREFERENCES
SECTION 2.10 FLOOR LIMIT
Set the maximum temperature you want the
floor to reach. The floor heating will not turn
on if the floor temperature is above the set
floor limit. If the floor limit is set too low, your
floor heating system will not turn on. nVent
NUHEAT suggests leaving the floor limit at
the default factory temperature setting.
NOTE: This setting is not available if
Temperature Control is set to Air/Room
temp. Refer to section 2.6 on page 11.
Press Cancel to ignore the change or press
Save to confirm.
SECTION 2.11 SCREEN BRIGHTNESS
Set the desired screen brightness.
Press Cancel to ignore the change or press
Save to confirm.
SECTION 2.12 SCREENSAVER
The thermostat will display the screensaver
after two minutes of inactivity. You can
choose what information to display on the
screensaver.
Press Cancel to ignore the change or press
Save to confirm.