Instructions / Assembly

DETAIL #13
DETAIL #14
p.10
Locate the "R" mark closest to the "A" mark. With roof bracket Section "1" as a guide,
position the bracket on the "R" mark and drill three 1/4" pilot holes through the roofing and
into the rafter. Now attach Section "1" of each roof mount bracket using three 3/8" x 4"
galvanized lag bolts with a washer under each head. Do not completely tighten at this time.
(See Detail #14) Be sure to center the lag bolts in the middle of each of the oval slots and
apply sealant around each bolt at the time of installation. On wider awnings, center
additional brackets and install over roof rafters. Important: Before securing lag bolts, be
sure all roof brackets are on the same plane. TIP: Stretch a piece of string along the front
of all the roof brackets and adjust as necessary. The oval slots in Sec. "1" allow this piece
to be adjusted. Once all the Sec. "1" pieces are attached and on the same plane, they can be
tightened securely to the roof.