Dimensions Guide

ManualsBrandsNuImage Awnings ManualsAwnings7 ft. 1100 Series Door Canopy Aluminum Awning (12 in. H x 24 in. D) in Almond

Measuring & Ordering Worksheet

This worksheet is intended to be a helpful resource in preparing your home for the installation of your NuImage® Awning. It is important to determine wall

space measurement requirements prior to purchase to ensure successful installation. If you need further assistance with your measurements, or if you have

any questions about area preparation for your installation, please call a NuImage Customer Care Representative at 1-800-901-3313.

www.nuimageawnings.com

Projections are approximate and may

be changed by moving arm mounting

location.

110 0

ALUMINUM DOOR CANOPY

WITH SUPPORT ARMS

Canopy Model # 4 5 6 7 8 9 10

Projection 24" 30" 36" 42" 48" 54" 60"

Step #1 Step #2 Step #3

Quantity

Canopy Model #

4, 5, 6, 7, 8, 9, or 10

Canopy width in inches Canopy Color Stripe Color

Measuring and Ordering

Information

Complete order information section below

using steps 1 through 3.

STEP 1

Canopy Model Numbers 4 through 10:

Using the chart provided, choose the appropri-

ate canopy model# that matches the projection

that best ts your needs. If mounting over an

out swinging door use at least a model # 7.

STEP 2

Canopy Width: Measure outside width of door

casing. Add at least 3" - 5" on each side for prop-

er appearance (be sure light xtures are not in

the way). Custom widths up to 120" in 1-inch

increments.

STEP 3

Color/Pattern Choice: Select the color(s) and

pattern that best complements your home. The

canopy top may be ordered in a solid color or

striped pattern. Support arms are always white.

Special orders are not returnable.

Verify all information before ordering.

Solid Striped

Width

Projection

Support arms require 3" of mounting

space over door (B).

If sidewings are desired, please order

Series 1500.

ORDER FORM: SERIES 1100 ALUMINUM DOOR CANOPY WITH SUPPORT ARMS