Installation Guide

Align Canopy Rafter with pre-punched holes in the center of the Top Trim first
and secure with small screws. Then, repeat with the other end of the Canopy
Rafter in the center on the Front Gutter and secure with small screws.
NOTE: Door canopies wider than 60” need more than one canopy rafter.
Pre-punched holes will guide installation of multiple canopy rafters.
Connect Canopy Slat Section to the Canopy Rafter using Interlock Clips at each
joint where the slats interlock. Installing clips is a two-step process: (1) Insert
the curved part of clip into slat joint; (2) Slide clip onto Canopy Rafter. Interlock
Clips are installed on the flat section of the awning only, not at the curve. If
stubborn, make sure they are straight and parallel with the slat joint.
Install Mounting Bar and secure with large screws above the door. Support
Arms require a minimum of 3 inches above door. Be sure the Mounting Bar
is level and centered over the opening. Screws must be in studs or heavy
sheathing. (Drill alternate holes in bar if necessary.)
l
!
Caulk the top of the Mounting Bar against the house.
Attach Support Arms on Front Gutter with small screws. Install Deluxe Castings
to opposite ends of Support Arms and hand-tighten set screws. The Deluxe
Castings will need readjusting and leveling when fastening to the house.
For awnings 85” wide and over, attach a third arm in the center.
Canopy
Rafter
Interlock
Clip
Caulk
Mounting
Bar
3-inch
minimum
Deluxe
Castings
Arm
Front
Gutter
Adjust Support Arms for desired pitch. Be sure door opens completely before
attaching. Align Deluxe Castings, level and secure to wall with large screws.
Tighten set screws on brackets.
Installation of door canopy with Support Arms is now complete.
Deluxe
Castings
Top Trim
8
9
Installation Instructions
10
3
1
Support Arms
SERIES 1100
FIG. 8
FIG. 9
FIG. 1
FIG. 10
2
FIG. 3
small screw
lift
canopy
upward
insert
FIG. 2A
FIG. 2C
Lift the front of the canopy upward
and insert the Top Trim into the
Mounting Bar (FIG. 2A). Lower front
of canopy slowly and allow Support
Arms to rest on the house (FIG. 2B);
be sure the two parts are completely
interlocked. Align holes and secure
Top Trim to Mounting Bar with small
screws from bottom side (FIG. 2C).
interlocked
lower front
of canopy
slowly
support arm
deluxe
casting
FIG. 2B