Installation Guide

ManualsBrandsNuImage Awnings ManualsAwnings4.5 ft. 1500 Series Door Canopy Aluminum Awning (15 in. H x 36 in. D) in Bedford Blue

Mounting Bar Edge Rafters (2) Support Arm (85” and over) Small Screws

Top Trim Canopy Rafter(s) Deluxe Casting (85” and over) Large Screws

Front Gutter Slat Sections Interlock Clips

Actual Size End Views of Door Canopy parts for easy reference and assembly:

mounting bar (a)

top trim (b)

SIDEWINGS 2

SUPPORT ARM

For use on awnings

85” and over only)

SLAT SECTIONS

410 based on model ordered

DELUXE CASTING

front gutter (C)

EDGE RAFTER 2 (D)

Canopy rafterS (e)

Phillips, Regular & 1/4” Hex Head

Screwdrivers or Bits Channel Lock Pliers Power Drill Level Tape Measure

Series 1500 Parts Check List:

Series 1500 with Sidewings

Required Tools:

QUANTITIES & SIZE OF PARTS MAY VARY BY AWNING SIZE AND MODEL SERIES

Mounting Bar (A) Top Trim (B) Front Gutter (C) Edge Rafter (D) Canopy Rafter (E)

It is our recommendation that you read instructions carefully

prior to assembly and installation.

Series 1500

Aluminum Door Canopy

with Sidewings

SLAT SECTION SEAMS

www.nuimageawnings.com

Summary of content (4 pages)

PAGE 1
www.nuimageawnings.com Series 1500 Aluminum Door Canopy with Sidewings It is our recommendation that you read instructions carefully prior to assembly and installation.
PAGE 2
Assembly Instructions Series 1500 Aluminum Door Canopy with Sidewings It is important that the Canopy Slats are assembled properly so that rain water will not leak through the seams where the slats join. 1 The canopy is assembled upside down. Note that the Slat Sections are packaged upside down (FIG. 1A). Assemble on a flat surface. Slats have a slight curve to them. Keep them this way for assembly. FIG. 1A l! CAUTION: Canopy parts may have sharp edges. Use care in assembly.
PAGE 3
8 Align Canopy Rafter with pre-punched holes in the center of the Top Trim first and secure with small screws. Then, repeat with the other end of the Canopy Rafter in the center on the Front Gutter and secure with small screws. Top Trim NOTE: Door canopies wider than 60” need more than one canopy rafter. Pre-punched holes will guide installation of multiple canopy rafters Canopy Rafter FIG.
PAGE 4
Adjust Sidewings so they are vertically plumb. Attach Sidewings to house with large screws. 4 Installation of door canopy with Sidewings is now complete. FIG. 4 5 For awnings 85” wide and over: Adjust Support Arms for desired pitch. Be sure door opens completely before attaching. Align Deluxe Castings, level and secure to wall with large screws. Tighten set screws on brackets. Installation of door canopy is now complete. Deluxe Castings FIG.