How to Guide

page 15 | Retractable Awning Installation & Operation Manual
4-7
continued from previous page
Detail #11
!
IMPORTANT!
Be careful not to hit
the fabric with the
brackets as it can
cause a tear or hole
that is not covered by
the warranty.
STEP 2
Install your Weatherguard
Cover onto the square bar.
This step will require at least
2 people.
With the Cover facing the
proper direction, see Detail
#11, lower the cover brackets
down onto the square bar.
Insert the cover bracket clamping screws and tighten the cover brackets onto the square
bar. Carefully remove any and all remaining packing materials including the plastic slip
covers holding the arms closed.
Cover Bracket
secured onto
square bar.
Slide Cover Brackets BEHIND fabric roll
to properly attach to square bar.
Lower Cover facing front, BEHIND fabric roll, and
secure cover bracket down onto square bar.
FABRIC ROLL
Continue now to section 5 of this manual: Awning Operation (page 16)
Detail #6
Detail #6A Detail #6B
The gear loop will be at
the bottom of the awning.
Secure the square bar to
the mounting brackets
with the clamping bolts
supplied, see Detail #6B.
Be sure the mounting bar
is seated ush to the back
of the bracket.
Slide the clamping bolts up
through from the bottom
of the bracket and thread
into the top hole. Be sure
to tighten completely so
that the locking lip on the
inside of the mounting
bracket locks down over
the square bar.
4-8