User manual

25
2. Put the battery in its compartment as
indicated on the unit. Make sure you
insert it with the correct polarity (+ and -).
3. Slide the battery cover 9 back onto the
parent unit 8.
4. Insert the small plug of the mains adapter
into the mains adapter socket 19 of the
parent unit.
5. Insert the plug into a power socket that
matches the rating given in the technical
data (see "9. Technical data" on
page 31).
6. Initially, charge the parent unit
continuously for 10 hours to activate the
full battery capacity.
Subsequently the battery will take only
about 5 hours to charge. It can also be
charged while the unit is in operation.
The POWER 15 LED indicates that
charging is in progress. If it:
– flashes green: the battery is currently
being charged;
– lights up green: the battery is fully
charged;
– lights up red and beeps at one minute
intervals: low battery warning. Within
about 15 – 20 minutes the parent unit
will switch off automatically.
4.2 Connecting the baby unit
Note: Don’t install the baby unit 1 until the
battery of the parent unit 8 is fully charged.
1. Put the baby unit 1 somewhere in the
nursery where your baby will not be able
to reach it.
An optimal distance between baby and
the baby unit is from 1 to 2 m.
2. Insert the mains adapter plug into the
socket 3 of the baby unit 1.
3. Insert the plug into a power socket that
matches the rating given in the technical
data (see "9. Technical data" on
page 31).
4.3 Connecting baby unit and
parent unit
1. Use the On/Off button 5 to switch the
baby unit 1 on. Keep the button pressed
for a moment until the Power LED 6 lights
up.
2. Use the On/Off button 14 to switch the
parent unit 8 on. Keep the button pressed
for a moment until the LED 15 lights up a
steady green.
The connection will be set up
automatically. While this is being done
the connection indicator 13 will light up
red.
As soon as the connection has been
established, the connection indicator on
the parent unit 13 and the VOX LED on
the baby unit 7 will light up green.
If the connection indicator 13 begins to
flash green, this means that there is a
connection between the parent unit and
the baby unit, but your baby is currently
asleep and therefore the device has
automatically activated Eco-Mode to
reduce the high-frequency radiation in
the children’s room and save energy.
In the event that the connection between
the parent unit and the baby unit breaks
down, the devices will automatically attempt
to establish a new one.
If a new connection is not established within
30 seconds, the parent unit 8 will emit a
regular beep and the connection
indicator 13 will light up red. You may need
to move the parent unit to a different
location before a new connection can be
established.
3. First go and check on baby to make sure
everything is OK.
4. Then try to set up a new connection by
moving about.
The connection will be automatically re-
established as soon as you are within
range.