User's Manual

● Cautions for use
▪ Before using CANICOM 400, we advise you to have your dog checked by your vet to ensure it is fit
to wear a collar.
▪ The CANICOM receiver collar is totally waterproof. Your dog can swim in water. In order to
maintain water tightness, we recommend the replacement of the seal located in the receiver collar
every year.
▪ The CANICOM 400 remote control is showerproof only. It is only designed to remain a short
time in the rain. Put it safe from water as soon as possible. If the remote control falls into the water,
it could be damaged in an irreversible way.
▪ Your dog should not wear any medal, metallic collar, or any other kind of collar together with the
CANICOM training collar.
▪ Avoid placing the remote control close to objects sensitive to magnetic fields, they could be
irreversibly damaged.
▪ Do not place or keep the unit in places exposed to high temperatures.
▪ It is necessary to replace the battery every two years, even if the unit has not been used for long
periods.
▪ Never leave a discharged battery in the unit: leakage could damage your CANICOM 400.
▪ Remove the battery from the receiver collar and the remote control if you are not using the
appliance for 3 months or more. The collar will memorize the configuration chosen (coding).
▪ Keep your CANICOM 400 unit out of reach of children. It is not a toy for you or your children.
● Maintenance
▪ Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
▪ In order to maintain water tightness, we recommend the replacement of the seal in the receiver
collar every year.
● Troubleshooting
Should your CANICOM 400 stop working or develop a fault, first read this user’s guide over, and then
check the batteries and replace them if necessary (see § Checking/replacing battery of remote control and
§ Checking/replacing battery(ies) of receive collar(s)). Also check that you are using the product
correctly.
If you encounter any problems, re-code the receiver collar (Ref. Recoding procedure).
Reinitialize the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) put in connection the 2 battery contacts for 2 seconds approximately. Insert the
battery again: one beep is emitted, indicating the battery is in correct position
.
Restart your CANICOM 400 using the remote control.
If the problem persists, contact your distributor.
Reset: connect the 2
supports of the battery
Diagram 11
According to the extent of the malfunction, you may have to return your product for check and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
CANICOM 400 – user-s guide – indice A 9/12