User’s guide « FCC » DECLARATION OF CONFORMITY FCC rules – part 15 NUM’AXES declares that the training collar CANICOM 200 First complies to all dispositions of the part 15 of the FCC rules This device complies with part 15 of the FCC. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference that may cause undesired operation.
WARNING Any person with individual device for cardiac assistance (pacemaker, defibrillator) must take precautions when they use CANICOM 200 First. This device emits some static magnetic fields (a magnet is located in the remote control). (Frequency= 915 MHz, at = 0.75 mW). The device complies with part 15 of the FFC rules.
● Contents of the product CANICOM 200 First Inside the packaging you will find: - a CANICOM receiver collar equipped with short contact points - a 3 Volt CR 2 lithium battery for the collar - a CANICOM 200 First remote control equipped with a 3 Volts CR 2430 lithium battery - a neon test lamp - a pair of long contact points - a carry strap - this user’s guide ● Description of the product Indicator of radio transmission + battery level indicator Beeper button Continuous stimulation level 1 Continuous s
▪ ▪ Activate: approach the red area where the magnet is located inside the remote control until coming in contact on red mark located on the receiver collar for 1 second (ref. Diagram 4). The indicator light on the collar will flash in green indicating the CANICOM receiver is ready. Deactivate: approach the red area where the magnet is located inside the remote control until coming in contact on red mark located on the receiver collar for 1 second (ref. Diagram 4).
If you press the “Beeper” button on the remote control, the receiver collar will emit sound signals. There is no time limit for this function: the beeper will continue to sound as long as you press the button. The indicator light on the collar goes from flashing green to permanent green as long as you press the button. It is up to you to use the beeper button depending on the way you want to train your dog.
● How to check that your CANICOM 200 First is functioning properly You can check that your CANICOM 200 First is operating correctly at any time. ▪ Before doing so, make sure that the receiver collar is turned “Off”. ▪ You can place the neon test lamp in contact with each of the contact points (by unscrewing them, then by screwing them up in order to grip wires of the lamp under the contact points). ▪ Turn “On” the remote control and receiver collar.
▪ ▪ ▪ ▪ ● Maintenance ▪ ▪ ● Remove the battery from the receiver collar and the remote control if you are not using the appliance for 3 months or more. The collar will memorize the configuration chosen (coding). It is necessary to replace the batteries every two years, even if the unit has not been used for long periods. Never leave a discharged battery in the unit: leakage could damage your CANICOM 200 First. Keep your CANICOM 200 First unit out of reach of children.
● Guarantee NUM’AXES guarantees the product against production defects for 1 year after purchase. All postage and packing charges will be the purchaser’s sole responsibility. ● Guarantee conditions 1. The guarantee will be valid only if the proof of purchase (invoice or sales receipt), without cancellation, is submitted to the distributor or to NUM’AXES. 2.
